Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ANH - switchport multi command

Hi,

On the Cisco 3512, 3524 and 3548 switches I can use the command "switchport multi" command at the interface configurtion mode to enable a port to be member of more than one vlan on this switch.

I tried this command on the Cisco 2950-12 G switch and I didn't find it.

Doesn't the Cisco switch 2950-12G support the switchport multi command?

If not , what are the alternative that I can use in case I don't have network cards that support trunking?

Thanks

1 REPLY
Cisco Employee

Re: ANH - switchport multi command

You are correct. Multi-VLAN port is not supported in 2950/3550. Trunking is the only alternative

101
Views
5
Helpful
1
Replies
CreatePlease login to create content