ANI Discovery - Hardware switched out/Model changed
I have switched a 3548 with a 4006, using the same IP address and DNS name. ANI continues to discover the device as a 3548. What is the best way to get the device discovered as the correct model, both through ANI and RME? I am running LMS 2.2 with RME 3.5. Is a reinit.pl the only way - and does that remove the Network Topology and User tracking info?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...