Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ANI Server - Unknown device-Cat6500

Hi,

I'm running running CW2K with ANI Server Version 4.2 and when I add a 6500 (Sup1A) to the ANI server as a seed device it says the device type is 'Unknown', and as a result not discover any other attached devices. It will discover attached devices when adding a 3500, 2900, etc. but not the Sup1A. The 'C6509' does show up on the Device Support page.

Has anyone else seen this?

cma

  • Other Network Infrastructure Subjects
1 REPLY
New Member

Re: ANI Server - Unknown device-Cat6500

Best way to see what ANI supports is to go to:

Server Configuration->About the Server->About ANI Server->Devices Supported

Verify if 6509 is there. Then check the OID listed and see if you do an SNMP poll for the ProductsId for your 6509, do you get the same thing.

What Cat OS code is the 6509 running? Please make sure the SNMP strings match and CDP is enabled.

Check if surrounding devices are able to see the 6509 as a CDP neighbor and vice versa. Also, make

these neighbors as seed devices.

hope that helps

80
Views
0
Helpful
1
Replies
This widget could not be displayed.