Has anyone ever migrated a appletalk flat network to a appletalk routed network. The current network is using dynamic appletalk addresses, when I put a sniffer on I see network addresses in the range of 65000 and up. About 600 workstations. When I place the cisco 4506 interface with an appletalk dynamic address (appletalk cable 0-0) it never allows the appletalk protocol to come up.
"appletalk cable 0-0" tells your router to get information from a seed router which you don't have. You need to specify a cable range which will make your router the seed router. Any AppleTalk device that isn't in that range will probably have to reboot to get a new network number.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...