My customer wants to enable Appletalk routing on his router. They don't have it at the moment and all their Mac are on VLAN1. However, after enabling Appletalk routing on VLAN1 and two other VLANs(no MAC on these VLANs yet), some printers and servers cannot be found in Chooser. I removed all the AppleTalk routing on routers and then all printers and servers appear again in Chooser. Is it owing to the configurations of AppleTalk routing?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...