Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

appletalk traffic

I have seperate remote locations. I have layer 3 EMI. The switches are connected through fast ethernet interfaces with dot1q trunk encaps which is layer 2. My appletalk clients and printers will show up at all locations no matter which lan that client of printer is part of. Any ideas?

1 REPLY
Community Member

Re: appletalk traffic

Please check if you have configured the VLANs correctly.

You could probably use VTP pruning to prune the VLANs that need not go on the trunk. This would avoid unwanted VLAN information going through the trunk.

Found some info.might help.

http://www.cisco.com/univercd/cc/td/doc/cisintwk/itg_v1/tr1909.htm

I don't have experience with appletalk.

93
Views
0
Helpful
1
Replies
CreatePlease to create content