Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

applying rate-limit on a cisco 2950 switch

Hi, i am trying to apply a rate-limit on a cisco2950

switch interface.although the switch is accepting the commands, the rate-limit does not register any hits.

Can anybody suggest as to whether rate-limiting works on cisco 2950 l2 switch and if it does any solutions for the above.thanks in advance.

Regards,

Amit.

2 REPLIES
Cisco Employee

Re: applying rate-limit on a cisco 2950 switch

What version of code? How do you have it configured? The 2950 supports policing on ingress - you cannot policy outbound. If ingress policing, have you verified the classification parameters and/or the egress rate (compared to the hits or no hits being registered)?

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2950/12114ea1/2950scg/swqos.htm

New Member

Re: applying rate-limit on a cisco 2950 switch

Hi, i am applying ingress rate-limiting on the switchport.

the ios version is IOS (tm) C2900XL Software (C2900XL-C3H2S-M), Version 12.0(5)WC8, RELEASE SOFTWARE (fc1)

do i have to do policing or will rate-limting will do the trick

361
Views
0
Helpful
2
Replies