I am currently running all of my cabling through a Krone IDF Cross Connect system and have several Async connections for Remote Consoles into Sun and Fujitsu servers. Some of the punchdowns were done with only one pair (w/Green and Green) for TX/RX. The connections seem to work fine, but I have a concern for the lack of grounding. Will the lack of a ground for these connections cause problems? Or is it mainly to keep things to spec?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...