Maybe I better start a new conversation for this, my message in the "AS5300 with Static IP" got somehow messed up...
Ok, I got the static problem sorted out, but I'm having another problem with my home Cisco 803 router (maybe with othet routers as well, haven't been able to test yet) and AS5300... After my original config which worked fine with Portmaster PM3 I've tried all the examples I've found from Ciscos site, without luck. It just woun't authenticate, or at least the connection doesn't come up.
Here is the As5300 config and some debugging, the problem seems to be in the end, Vi1 MLP etc... but what does it exactly mean? The C803 is using the plain NAT config found from Ciscos 800-804 software config manual.
Another problem I'm having, probably not related, is that my Viscom Radius server authenticates dialup users fine and even assigns static IP's if needed, but after that the server thinks ("sh users" in the radius server) all users are having 0.0.0.0 address. AS5300 "sh users" as well as Windows clients "ipconfig" etc however show the addresses correctly, and the connection works fine. So it's only a cosmetic problem, but annoying. Any ideas?
Current configuration : 4291 bytes
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
aaa authentication login default enable
aaa authentication ppp default group radius none
aaa authorization network default group radius local
aaa accounting network default start-stop group radius
803 is trying to negotiate the multilink connection with as5300.."debug aaa authorization" will report more but AS5300 is trying to clone virtual access interface but since virtual template interface is not configured, its dropping the connection..Are you trying to pass authorization parameters from aaa to AS5300 for that user??
To fix this issue configure the following
multilink virtual-template 1
interface virtual-template 1
ip unnumbered Loopback0
peer default ip address pool dialin_pool
ppp authentication chap pap
Problem should be solved with that..If not need following debug
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...