cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
254
Views
0
Helpful
2
Replies

as5300 callback always disconnect the call

intosea
Level 1
Level 1

I config as5300 with callback,but when as5300 successful call back to the remote client,after 2 minutes, the call always being disconnected, I don't know why? thanks!

Benny

2 Replies 2

makchitale
Level 6
Level 6

Maybe you have "dialer in-band" under the "interface group-asyn x", and do not have interesting traffic defined to reset the dialer idle-timeout....this defaults to 120 secs.

Ideally we do not need the dialer in-band command. Pls refer to:

http://www.cisco.com/warp/public/793/access_dial/async_ppp.html

Thanks, Mak.

Just to add, if you have to have DDR related commands like dialer in-band and dialer idle-timeout, for may be non-callback users, you need to properly configure the AS5300 for that,

Here is the url which explains configuring and troubleshooting idle-timeout related issues.

http://www.cisco.com/warp/public/471/idle_timeout.html

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco