Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

as5300 callback always disconnect the call

I config as5300 with callback,but when as5300 successful call back to the remote client,after 2 minutes, the call always being disconnected, I don't know why? thanks!

Benny

2 REPLIES
Silver

Re: as5300 callback always disconnect the call

Maybe you have "dialer in-band" under the "interface group-asyn x", and do not have interesting traffic defined to reset the dialer idle-timeout....this defaults to 120 secs.

Ideally we do not need the dialer in-band command. Pls refer to:

http://www.cisco.com/warp/public/793/access_dial/async_ppp.html

Thanks, Mak.

Cisco Employee

Re: as5300 callback always disconnect the call

Just to add, if you have to have DDR related commands like dialer in-band and dialer idle-timeout, for may be non-callback users, you need to properly configure the AS5300 for that,

Here is the url which explains configuring and troubleshooting idle-timeout related issues.

http://www.cisco.com/warp/public/471/idle_timeout.html

98
Views
0
Helpful
2
Replies