Cisco Support Community
Community Member

AS5300 Configuration

Can someone give me some assistance in configuring an AS5300 as a dial-up server. I'm not that familiar with this box. We are re-deploying one that worked fine with a PRI from Verizon, but now we are using a PRI coming from our own switch (Nortel DMS-500) and we cannot get it to work. I've tried using the existing PRI config. (set for DMS switch), and I've also tried several variations and none of them worked. When we take this same PRI and put it in an old 3Com Total Control box it works just fine. I'm at a loss as to why we cannot get it to work with the AS5300. Any ideas??

Cisco Employee

Re: AS5300 Configuration

We need to debug at isdn q931 along with the ppp level. By the way here is the url which helps you for configure and troubleshooting

In that url pl. make sure that you configure the isdn switch-type for dms500 as dms100

isdn switch-type primary-dms100

If the things still dosen't work then we need to take a look at following debug with sh commands

debug isdn q931

debug dialer

debug ppp authentication

debug ppp negotiation

term mon


sh isdn status

sh run


CreatePlease to create content