Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

AS5300--E1 R2 country code

Hi All,

What should I use in the following command as my country is not listed in the country code list.

5300(config-ctrl-cas)#country <country> use-default

Thanks in advance,

Richard

2 REPLIES
Silver

Re: AS5300--E1 R2 country code

Try to find the standard used by your country for E1R2 signalling and configure that in your configuration

The mica modem needs a country code specified as well,

modem country mica

If the standard is different specify the applicable modem.

In case this doesn't help you need to specify your country settings under cas-custom sentence,

5300(config-controller)#cas-custom 0

5300(config-ctrl-cas)#?

CAS custom commands:

Also use the following debug commands

debug isdn q931

debug cas

debug modem

debug modem csm

debug vtsp all

Community Member

Re: AS5300--E1 R2 country code

Thanks, ivillage! I am new to this E1 thing, but it would be great to configure as5400.

Thanks and best regards

Richard

163
Views
0
Helpful
2
Replies
CreatePlease to create content