Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AS5300 failed authentication


I am using an AS5300 for authentication for a small ISP. I have two T1's for connection and 48 modems. When I try to do a multilink ppp connection with ISDN my authentication fails, but if I change it to use only a single line the authentication works just fine. Any thoughts on why this happens?


  • Other Network Infrastructure Subjects

Re: AS5300 failed authentication

We’ll need to look at debug ppp negotiation and debug ppp authentication to see what’s happening during the event. I would get those together and call TAC.

New Member

Re: AS5300 failed authentication

Here is the debug for it:

23:16:32.626: ISDN Se0:23: RX <-  SETUP pd = 8  callref = 0x01C1

23:16:32.626:         Bearer Capability i = 0x8890

23:16:32.626:         Channel ID i = 0xA98393

23:16:32.626:         Calling Party Number i = '!', 0x81, '2625229082'

23:16:32.626:         Called Party Number i = 0x80, '1011'

23:16:32.634: %LINK-3-UPDOWN: Interface Serial0:18, changed state to up

23:16:32.638: ISDN Se0:23: TX ->  CALL_PROC pd = 8  callref = 0x81C1

23:16:32.638:         Channel ID i = 0xA98393

23:16:32.638: ISDN Se0:23: TX ->  CONNECT pd = 8  callref = 0x81C1

23:16:32.638:         Channel ID i = 0xA98393

23:16:32.666: ISDN Se0:23: RX <-  CONNECT_ACK pd = 8  callref = 0x01C1

23:16:34.442: %ISDN-6-DISCONNECT: Interface Serial0:18  disconnected from

9082 ventisdn, call lasted 1 seconds

23:16:34.442: ISDN Se0:23: TX ->  DISCONNECT pd = 8  callref = 0x81C1

23:16:34.442:         Cause i = 0x8090 - Normal call clearing

23:16:34.486: ISDN Se0:23: RX <-  RELEASE pd = 8  callref = 0x01C1

23:16:34.494: %LINK-3-UPDOWN: Interface Serial0:18, changed state to down

23:16:34.498: ISDN Se0:23: TX ->  RELEASE_COMP pd = 8  callref = 0x81C1

This widget could not be displayed.