AS5300 ---> console connection but will not ask for a login
I am connected to a as5300 through the console port and when I hit return to enter the system it tells me to hit return to continue. I hit return and it tells me again to hit return. I captured the following:
%SYS-4-CONFIG_NEWER: Configuration from version 12.1 may not be correctly unders
%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...