Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AS5300 using radius

We are using AS5300 for dial up costomer and authenticate using radius.

This RAS is connected with four leased line.Till now I am using IP Unnumberred in in interfaces.

But NOw I want to assign IP add in these interface.

Now should I mention the all four address in radiator??

1 REPLY
Silver

Re: AS5300 using radius

From what I understand, the serial interfaces (lease line) are using ip unnumbered till now.......now you want to assign ip addresses directly to these interfaces, correct?

conf term

interface s0

ip address x.x.x.x x.x.x.x

I guess you are not thinking of making the "interface group-asyn x" from ip unnumbered to an ip addressed interface...

Thanks, Mak.

86
Views
0
Helpful
1
Replies