Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AS5350 & Cisco DialOut Utility

I am currently trying to set up Cisco's DialOUt utility using an as5350. I am able to make outgoing calls using the modems on our as5350. The DialOut utility suggests using port 7001 to connect to the modem. The problem is that I have to use port number 2218 or 2219 to make the call successfully. When I try to use port 7001, the call fails and I get a message saying "no carrier". Any suggestions?

3 REPLIES
Bronze

Re: AS5350 & Cisco DialOut Utility

port 7001 is TELNET binary mode to a rotary group; to use dialout, you should use binary mode. Ensure that your lines are all configured with "rotary 1", that may explain your problem.

If you still have problems, you might consult this page:

http://www.cisco.com/warp/public/471/Non_DDR_callout.html

New Member

Re: AS5350 & Cisco DialOut Utility

Thanks for the response. All my lines are configured with rotary 1. Is there anything else I need to add on an as5350?

Bronze

Re: AS5350 & Cisco DialOut Utility

Whats your complete config under the tty lines? Make sure you have modem inout, rotary 1, transport input all in there.

~Zulfi

325
Views
0
Helpful
3
Replies
CreatePlease to create content