Catalyst 6503 with SUP2/MSFC2 running native IOS (service provider) - is it possible to assign hosts to specific VLANs based only on MAC address without using any other management software?
48-port 10/100 blade. We're planning to use 802.1X on ports 1-24. For ports 25-48 we will connect non-802.1X clients but we would like to automatically assign them to specific VLANs based on their MAC address.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...