Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

assigning multiple ip addresses to ethernet port on 1750 router

Hi,'

We have a 1750 router with one ethernet port and two serial port. we want to connect the two serial port to two different ISPs for Internet access. Since each ISP has allotted us with two different sets of IP addresses and will allow packets from their IP address to pass through their network, we need to configure the ethernet port with 2 different ip addresses as in ip aliasing. Is it possible? If yes, How?

All suggestions are welcome.

Mahendra

1 REPLY
Bronze

Re: assigning multiple ip addresses to ethernet port on 1750 rou

Hi Mahendra,

you can configure a second ip address on an interface using the "secondary" keyword, like this:

interface ethernet0

ip address 10.0.0.1 255.0.0.0

ip address 192.168.0.1 255.255.255.0 secondary

You will also have to implement Policy Based Routing (PBR) to make sure that packets with a source address in ISP1's range go out via serial1 and likewise for ISP2.

See http://www.cisco.com/en/US/customer/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800c75d2.html for more info.

hth

Herbert

97
Views
0
Helpful
1
Replies
CreatePlease to create content