10-26-2002 11:36 PM - edited 03-02-2019 02:24 AM
Hello All,
I've 2924 Switch in my Network . I would like to know how to assign all the ports ( 1-24 ) to particular Vlan using single command in CLI .
Thanks.
Raju.
10-27-2002 02:04 AM
.
10-27-2002 03:24 AM
You would use the "interface range" command for this. But I believe the command is only available in the 3550 and higher switches (eg 3550, 4000, 6000 series switches).
I know the 2948G-L3 and 2950 don't support this.
Hope it helps.
Steve
10-27-2002 08:56 AM
The 2950's do support the range command, but the XL's do not
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide