We're trying to tunnel RS-232 data across a small IP network to remotely monitor/control serial devices. The end devices require DCD to be held high from the router. Working with TAC, so far the AUX port doesn't seem to be able to do this, so we would have to disable flow control, which isn't a viable solution.
1) Do other serial interfaces have the ability to hold DCD high?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...