Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATM clock source does not revert back to priority with NCDP

We have an ATM network with 8540 and 8510 ATM switches. We have designed NCDP in such a way that that the priority 1,2,3,4 clock sources are the PABX. Priority 5 clock source is the internal system clock. Every few day we believe that there is a PABX issue whereby the clock fails over to the priority 5 internal system clock which is fair enough. But when the PABX clock becomes stable again the 85xx switches don't revert back to the PABX clock and stay using the internal system clock, although we have configured to revert. As a temporary work-around we have to remove and re-apply the ncdp commands for the 85xx to start using the PABX clock again.

1 REPLY
Bronze

Re: ATM clock source does not revert back to priority with NCDP

The following example shows how to configure the network clock to revert to the highest priority clock source after a failure and takeover by the source with the next lowest priority.

Switch(config)# network-clock-select revertive

http://www.cisco.com/en/US/products/hw/switches/ps718/products_configuration_guide_chapter09186a00801eda20.html

239
Views
0
Helpful
1
Replies