Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ATM command

Does anyone know what the command to set on the router so that it query the switch for its addressing and only do so every 5 min.?

1 REPLY
Cisco Employee

Re: ATM command

Could you give us more informations ? I assume you mean that the router gets the NSAP address from the router. If well, the router gets the address by ILMI at the link up event. Why should it be refreshed ? SSCOP will bring the link down if the remote end dies, in the case that the router and switch were not directly connected. Check: http://www.cisco.com/warp/customer/121/ilmi.html for more details. Hope it helps, Karim.

125
Views
0
Helpful
1
Replies
CreatePlease to create content