Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATM interfaces

What is the limit for atm subinterfaces?

Ex. ATM2/0.1 through ATM2/0.99

Then it would go to ATM2/1.0

Then on through ATM2/9.99

Is that correct?

Thanks in advance.

3 REPLIES

Re: ATM interfaces

Often times complex configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: ATM interfaces

Under this ATM interface if you type this command you get!

int atm5/0.?

0-4294967295

That number looks like the total number of subnet interfaces. Also I imagine that it will depend on the hardware and its limitations.

New Member

Re: ATM interfaces

Logically you can use the subinterface up to 4294967295 but the real boundary is the memory capacity. Because every single logical interface will take up some space in the RAM.

Thus it depends on your RAM size.

224
Views
0
Helpful
3
Replies