Re: ATM link between VIP2-40/PA-A3-OC3-SMI and Cat5000 with RSM
Bridged RFC1483 is probably the only option you have. For LANE or SVCs you need to have an ATM switch (like a LS1010) in the middle. If you have a 5500 series switch you can buy modules for the LS1010 and build a switch within a switch. Hope this helps.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...