Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ATM load balancing question

What would be the best way to load balance ATM where there are 2 PVCs (one CBR and one VBR-RT). Currently the CBR PVC is used only one hour per day for videoconferencing and it would be good to load balance this PVC for the other 23 hours. I was looking at tag switching but don't know if this is the best way. Thanks.

2 REPLIES
VIP Purple

Re: ATM load balancing question

Hello,

I am not sure if this works for ATM PVCs, but you could try a virtual template, this is a generic view of what it would look like:

interface ATM0/0/0.1 point-to-point

pvc 0/34

vbr 100 80

protocol ppp Virtual-Template1

interface ATM0/0/0.2 point-to-point

pvc 0/35

cbr 100 80

protocol ppp Virtual-Template1

interface Virtual-Template1

ip address 82.16.1.2 255.0.0.0

ppp multilink

As I said, I have not tried this in a live environment...

Regards,

Georg

New Member

Re: ATM load balancing question

Thank you very much Georg!!

118
Views
0
Helpful
2
Replies