I have two T1 configured as IMA in one location. The second location is one T1 that is frame-relay. I can't seem to get the serial interface on second location up. Can I anybody tell if I've configured it correctly?
location 1:
interface ATM2/0
no ip address
no atm ilmi-keepalive
ima-group 1
no scrambling-payload
!
interface ATM2/1
no ip address
no atm ilmi-keepalive
ima-group 1
no scrambling-payload
!
interface ATM2/2
no ip address
shutdown
no atm ilmi-keepalive
no scrambling-payload
!
interface ATM2/3
no ip address
shutdown
no atm ilmi-keepalive
no scrambling-payload
!
interface ATM2/IMA1
no ip address
no atm ilmi-keepalive
!
interface ATM2/IMA1.200 point-to-point
description PVC to Baltimore
ip address 172.25.3.213 255.255.255.252
pvc 1/200
oam-pvc 0
encapsulation aal5snap
!
!
interface ATM2/IMA1.210 point-to-point
description PVC to London
ip address 172.25.3.217 255.255.255.252
pvc 1/210
oam-pvc 0
encapsulation aal5snap
location 2:
controller E1 0/0
linecode ami
channel-group 0 timeslots 1
!
!
!
interface FastEthernet0/0
ip address 192.168.2.103 255.255.255.0
speed 100
full-duplex
!
interface Serial0/0:0
description AT&T PVC to Pasadena
no ip address
encapsulation frame-relay IETF
no fair-queue
frame-relay lmi-type ansi
!
interface Serial0/0:0.212 point-to-point
description AT&T Frame-Relay to Pasadena
ip address 172.25.3.218 255.255.255.252
frame-relay interface-dlci 212
!
Thank you,
Joy
