ATM with SVC

[abbas.ali]

If I have r1 r2 r3 and r4 are running over ATM. r1 is the hub and configured ATM arp server self. r2,r3 and r4 will have to have an ATM arp server's NSAP address to configure with. Is it possible to get the nsap address from the r1 itself.

For example

r1 config,

int atm 1/0

atm pvc 1 0 5 qsaal

atm pvc 20 16 ilmi

atm-ilmi keepalive

int atm 1/1.0 multipoint

ip address 100.0.0.1 255.255.255.0

atm esi-address 1111.1111.1111.11

atm arp-server self

on r2,

atm 1/0

pvc 1 0 5 qsaal

pvc 2 0 16 ilmi

atm-ilmi keepalive

int atm1/0.1 multipoint

ip address 100.0.0.2 255.255.255.0

atm esi-address 2222.2222.2222.22

atm arp-server nsap?????

same for r3 and r4

If I am not allowed to telnet to the atm switch, then there has to be a way to get the nsap adress.

Thanks,

[svelayud]

Yes it is possible.

Do a show int atm 1/1.0 you will see something like this.

d11-5-7206-15#show int atm 1/1.0

ATM1/1.0 is up, line protocol is up

Hardware is ENHANCED ATM PA

MTU 4470 bytes, BW 149760 Kbit, DLY 80 usec,

reliability 138/255, txload 1/255, rxload 1/255

NSAP address: 47.009181000000009021449C01.111111111111.11

Encapsulation ATM

0 packets input, 0 bytes

0 packets output, 0 bytes

0 OAM cells input, 0 OAM cells output

AAL5 CRC errors : 0

AAL5 SAR Timeouts : 0

AAL5 Oversized SDUs : 0

Thanks

Suresh