Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Auto Configuration file population

Hi Folks,

I'm looking for the most effiencient and reliable way to load configuration onto 250 2911's. Here's the criteria; The devices will be set up in our lab and that is were the configuration will be carried out. they will all be using the same subnet. Obviously every configuration file will be different but large parts will be identical for every single device.

Is there a way to use dhcp to populate the IP addresses of the 2911's and then have some kind of process where a test switch or router pushes a configuration file to each node in that subnet?

It would be even better if we could push prepared indivdual config files to corresponding IP addresses but we can get a generic config file done I'd be happy

Regards

Ciaran

390
Views
0
Helpful
0
Replies
CreatePlease to create content