Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

autocommand line command not working

I am trying to use the aux interface on one router to communicate with the aux interface on another router. Connected to each aux interface is a vt100 type terminal. I have autocommand telnet 60.20.70.6 2004 configured on one router's line 4 interface and on the other routers line 4 interface I accept all connections. My understanding is that when I type / send data to the async port on the router with the autocommand, a telent session should start creating a raw tunnel between the 2 async ports. The routers have no problems with telnetting from a command line to the async on the other router. I just can't get the autocommand to work. Any suggestions?

4 REPLIES
Silver

Re: autocommand line command not working

What kind os boxes are they ?

you can do a sh users on the box that is receving the telnet you should see the host name of the box that has the autocommand configured .

Can you ping 60.20.70.6 from the box that has the autocommand configured ?

Community Member

Re: autocommand line command not working

The autocommand never starts. The show user never shows a user for the line in question. Yes I can telnet between the boxes.

Silver

Re: autocommand line command not working

can you paste in a sh line & a sh config from both

Silver

Re: autocommand line command not working

The configuration needs to be as follows:

http://www.cisco.com/warp/public/700/14.shtml

Thanks, Mak.

160
Views
0
Helpful
4
Replies
CreatePlease to create content