is there a way to automatically schedule an import from my local HPOV into the RME inventory database, either by configuration in the Web-gui or perhaps using some command-line utility invoked by cron ?
Any hints would be appreciated. Thank you very much,
You can import from the RME GUI from HPOV but currently there is no automated way to schedule the import. If there's way to export the device list from HPOV, then you can import it in RME from CLI and run it in a cron job etc.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...