Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

%AUTOSTATE-6-SHUT_DOWN: Putting interface Port-channel1.102 into Autostate mode

there is a catalyst 4003 with ws-4232-l3 route module ,it connects to the facility of Redback through 4 fast ethernet links, not port channel

someday,they didn't work well ,the four links were down ,but the other ports also worked well ,we did nothing,and information said Putting interface Port-channel1.102 into Autostate mode

31w5d: %AUTOSTATE-6-SHUT_DOWN: Putting interface Port-channel1.104 into Autostate mode

31w5d: %AUTOSTATE-6-SHUT_DOWN: Putting interface Port-channel1.105 into Autostate mode

31w5d: %AUTOSTATE-6-SHUT_DOWN: Putting interface Port-channel1.106 into Autostate mode

31w5d: %AUTOSTATE-6-BRING_UP: Taking interface Port-channel1.106 out of Autostate mode

after 8 minutes ,the port worked well automatically. i want to know the meaning of the information above ,what's the reason result in

1 REPLY
Anonymous
N/A

Re: %AUTOSTATE-6-SHUT_DOWN: Putting interface Port-channel1.102

When the last external port on a VLAN goes down, all Layer 3 interfaces/subinterfaces on that VLAN shut down (are autostated) unless sc0 is on the VLAN or another router is in the chassis with an interface/subinterface in the VLAN. When a Layer 3 interface goes down, this message is reported to the console for each Layer 3 interface

152
Views
0
Helpful
1
Replies
CreatePlease login to create content