Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

AUX line Async interface on AS5350

Hi!

Does anyone knows that Async interface conforms to AUX line 0 in AS5350 access-server ? This AS5350 contain two Universal Port Dial Feature Card with Async lines, and attempt to configure Async 1 interface produce following results (IOS:Version 12.2(2)XA):

dial#show line

Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int

0 CTY - - - - - 0 0 0/0 -

1 AUX 9600/9600 - - - - - 0 0 0/0 -

2 VTY - - - - - 24 0 0/0 -

* 3 VTY - - - - - 3 0 0/0 -

4 VTY - - - - - 0 0 0/0 -

5 VTY - - - - - 0 0 0/0 -

6 VTY - - - - - 0 0 0/0 -

1/00 Digital modem - DialIn - - - 0 0 0/0 -

1/01 Digital modem - DialIn - - - 0 0 0/0 -

1/02 Digital modem - DialIn - - - 0 0 0/0 -

....

2/58 Digital modem - DialIn - - - 0 0 0/0 -

2/59 Digital modem - DialIn - - - 0 0 0/0 -

Line(s) not in async mode -or- with no hardware support:

7-215, 276-323

dial#configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

dial(config)#int

dial(config)#interface Asy

dial(config)#interface Async 1

% Incomplete command.

1 REPLY

Re: AUX line Async interface on AS5350

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

122
Views
0
Helpful
1
Replies
CreatePlease to create content