Im working on a config for aux port async dial to backup a primary frame relay link (only using async do the non avalability of ISDN). Im planning on using the backup interface command against my frame realy sub interface. upon specifing the async interface as the backup interface, the async interface will be more or less shut down until protocol is lost on the primary link. Then the backup link will taken out of an addministrative shut down state.
Does anyone know if the interface is truely in shut-down, or a spoofing type of state? My goal is to avoid dialin attempts?
The async interface will be in "stand by" mode which means waiting to be active (close to shutdown mode)..If you avoid dialin on that line and only want to dialout on that line, use "modem dtr-active" under the line command..
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...