Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Available Bandwidth on E1 link

Hi,

We have an E1 connection between two sites. In the remote site we use a 2620 with a G.703 connector. The E1 controller is set up to use timeslots 1-31, so we should have 1984 kbit/s available bandwidth.

However, when I do show interface Serial0/0:0 it indicates that:

Available Bandwidth 1488 kilobits/sec

Do any of you know what could be causing this? Your help would be appreciated!

Regards,

Harald

1 ACCEPTED SOLUTION

Accepted Solutions
New Member
1 REPLY
New Member
535
Views
0
Helpful
1
Replies