07-11-2003 03:05 AM - edited 03-02-2019 08:48 AM
i tried ,but don't work. interface is up,but line protoco changes between up and down every 10 seconds,anyone has experienced this problem,thanks
07-11-2003 04:03 AM
You must have a DTE and a DCE cable for this to work . On the serila interface that is connected to the DCE cable you must supply clock , 'clock rate xxxxxx.
07-11-2003 05:07 AM
yes,i did it. i am wandering if there is hardware compatibility issues between
wic-2 a/s and 2501 serial interface?
07-11-2003 06:24 AM
Seems like the A/S interfaces have a much lower top speed in sync mode than the sync interfaces. What clock speed did you set?
07-11-2003 07:28 AM
64k
07-11-2003 07:52 AM
what is your encap ? make sure keepalives are configured on both ends .
past in the sh interface s x and the config for both serial interfaces .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide