I have insalled a flexwan WS-X6182-2PA module in my 6509 with PA-T3+ adapter. I'm trying to test it back to back. Is the configuration going to be same as for T1 back to back or differnt. any sample configuration and cable information would be greatly appreciated.
You can configure Pa=T3+ back to back, as you would the T1 interface, and need to set one side to provide the clock, while the terminating side to listen to for the clock. All other parameters must match. Link the Tx cable on one side to the Rx on the terminal side. and vice-versa.
Here is a link with more information on configuring PA-T3+:
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...