Back to back DS3

[nawas]

I have insalled a flexwan WS-X6182-2PA module in my 6509 with PA-T3+ adapter. I'm trying to test it back to back. Is the configuration going to be same as for T1 back to back or differnt. any sample configuration and cable information would be greatly appreciated.

[fmachoka]

You can configure Pa=T3+ back to back, as you would the T1 interface, and need to set one side to provide the clock, while the terminating side to listen to for the clock. All other parameters must match. Link the Tx cable on one side to the Rx on the terminal side. and vice-versa.

Here is a link with more information on configuring PA-T3+:

http://www.cisco.com/en/US/products/hw/modules/ps2033/products_configuration_example09186a0080093c71.shtml