Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

backup link on two parallel networks

Hi,

I am having intra web server connected to two parallel network, one is on ethernet and other is on token ring. Both the network is connected to other four offices. The network connected to ethernet card is having T1 connection with other four offices and network on token ring is 56K dialup.

Now I have to make 56k dialup network as a backup network for T1 network.

Please guide me.

Lots of thanks in advance

Amar

2 REPLIES
Gold

Re: backup link on two parallel networks

What routing protocol? You're easiest bet is to use the backup interface command, if you can, but otherwise it's going to be to set up a floating static route to point through the dial link as an alternative.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_c/dcdbakdp.htm

Might be what you are looking for...

Russ

Community Member

Re: backup link on two parallel networks

thanks a lot for the reply. When I join this project there was no routing protocols configured. They have configured static route.

Can I configured Routing and remote access on server and then configure floating route ???

Please help.

Amar

80
Views
0
Helpful
2
Replies
CreatePlease to create content