cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
269
Views
0
Helpful
1
Replies

Bandwidth Distribution

n.m
Level 1
Level 1

I have a 1601 router with two V.35 serial interfaces S0 and S1 and one Ethernet interface e0.

The interface S0 is connected with a 512 kbps E1 link to the Internet.

While the e0 interface is a 10 Mbps connected to a LAN.

The Question if there is any way that enable my to divid the incoming bandwidth from S0 on S1 and e0? Any possible way to do it in the IOS?

1 Reply 1

ciscomoderator
Community Manager
Community Manager

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: