Bandwidth issue

[Mohamed Sobair]

Hi All,

I have 2950 switch, multiple vlans created on it, Is there any way to configure specific vlan with particular bandwidth speed?

Also, if I configured specific port as follows:

(conf)int f0/2

bandwidth 2048000

Does the above means 2mb speed up/down?

thanks,

[pkhatri]

I'm afraid that will not achieve what you want. There is no way to limit all traffic to a specific bandwidth for a VLAN on the 2950.

I would suggest that you apply a QoS service policy on the router that does inter-vlan routing for this VLAN in order to achieve your rate-limiting.

Pls do remember to rate posts.

Paresh