The Bandwidth can be limited on the serial ports of a router using the bandwidth command. However, this feature is not available in a switch and hence the bandwitdth cannot be restricted although the bandwidth command might still be available in the cli. If the port is a fast ethernet port, you have a choice between 10 Mbps and 100 Mbps, but you cannot choose 20 Mbps. You could configure the switch to use 10 Mbps instead.
the bandwith configuration on a serial routerinterface does _not_ affect the traffic flow-rate itself. It's only for some routing protocols to calculate the best path (OSPF). Additionaly it is used for some QoS features (like CAR ...), but it has no traffic limiting capability itself.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.