I need some clarification regarding some statistics I'm pulling from the serial interface on a 2621 I have connected to a burstable T1. I'm pulling statistics from the Tx/Rx section where it gives the ratio used, ex. 6/255, or 320/255....and I'm also pulling stats on bitrate. My percentages are different on both portions....I need to know what the main differences are between the 'txload' and 'rxload' statistics vs. the bitrate stats. I know what each of them mean, but which one do I use when referring to bandwidth utilization? Please help....
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.