Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Bandwidth management on cisco 2600

on cisco 2610 router with 2 WIC and one eth module on which i have to distribute the internet of 512 Kbps in to 64 Kbps and 448 Kbps is this possible in 2600 series router if yes then how please help in this issue

  • Other Network Infrastructure Subjects
1 REPLY
Bronze

Re: Bandwidth management on cisco 2600

You can use route maps, match on ip addresses and then set interface to one of the two possible interfaces. You could refer to the document below for more info

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800c75d2.html

159
Views
0
Helpful
1
Replies
This widget could not be displayed.