Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

bandwidth mismatch in Point-to-Point link

In point-to-point serial link connection, if the bandwidth setting on both sides are not the same, will the connection status is up and running? What will the bandwidth be? The lower one?

1 REPLY
Purple

Re: bandwidth mismatch in Point-to-Point link

As I indicated earlier, the bandwidth configured at the interface level is only used for IGP metrics etc. If set to be different at either end, it will not affect the physical state of the interface. It will stay up.

However, it's better to make them the same.

PAresh

232
Views
0
Helpful
1
Replies