Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
540
Views
0
Helpful
3
Replies

Bandwidth Utilization

mowtnman
Level 1
Level 1

‎05-21-2003 04:45 AM - edited ‎03-02-2019 07:30 AM

Is there a good method for pulling statisitcs on Bandwidth utilization on routers / switches? Or do professionals use a program like Cisco Works for that kind of information?

Thanks in advance for your input.

Labels:
0 Helpful
3 Replies 3

michacarter
Level 1
Level 1

‎05-21-2003 05:16 AM

Try MRTG

http://people.ee.ethz.ch/~oetiker/webtools/mrtg/

Best regards,

Michael.

0 Helpful

mowtnman
Level 1
Level 1
In response to michacarter

‎05-21-2003 05:31 AM

I am currently using MRTG but I was looking for something else, whether they are commands for the router / switch to quickly look and see how much bandwidth is being used at any given time.

In order to use MRTG for some devices casuses a lot of policy changes to take place (i.e. punching holes into firewalls, etc.) So I was trying to find something that would give that kind of information on the fly...

0 Helpful

olorunloba
Level 5
Level 5
In response to mowtnman

‎05-21-2003 10:27 AM

If you do a show interface, one of the lines give the input and output rate. These values are the bandwidth utilisation (5 minute exponential average).

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents