I have a 2600 connected to 3 remote sites. The CSU/DSU is setting the clock rate. When I do a sho run, the 2600 has a bandwidth of 128 and my remotes a rate of T1. Using EIGRP.
Everything WAS fine till they upped the line speed from 2 channel to 6 channel. Now the link is up, down. Assuming the CSU/DSU is configured to the new speed, does the mismatch in bandwith have anything to do with the up, down?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...