the bandwith value of a serial port set by the "bandwidth" command seems not the real bandwidth of the port ,am I right ? if so, when I want to config the bandwidth of a serial port , can I set this vaule discretionarily
You are right.. The BW command does not effect the allowable BW of the link. It does however effect routing protocols and management (NMS) applications. So you'd likely effect some routing protocols route calculation and what management applications thing the allowable BW is.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...