Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Bandwith display errors using CMS on a 3524 switch

When i graphicaly display bandwidt using the CMS (revision augus 2002) on a 3524 switch, there seems to be a mis match between displaying the rate in Kbytes en % load.

There is also a substatial mismatch in wat is the real bandwith.

I tested i on a 2 Mbit internet feed (non overbooked) By DOWNLOADING A FILE the microsoft download progress displayed a rate of 1.8 Mbit, while the link graph on the same port displayded 4.000,000 Kbytes, that is 3,2Mbit.

Is this a well known problem.

Rolf

1 REPLY
New Member

Re: Bandwith display errors using CMS on a 3524 switch

If the link graph is showing 3.2 MB on a 2MB link, I would suspect a software issue. You may need to open a case with Cisco on this, or try the Bug Toolkit here: http://www.cisco.com/cgi-bin/Support/Bugtool/launch_bugtool.pl

106
Views
0
Helpful
1
Replies