Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Banner MOTD's

Just curious if anyone as experienced Banner's not being completed through Telnet. Had different configurations and sizes of banners. Even a simple:

banner motd ^C

TEST

^C

This would prohibit a telnet access. This was running fine other quipment running the same software and hardware, and many other locations.

When looking at the debug, it looks like the session never gets completed. Anyone else have sucha problem? What was the cause?

Thanks for any info.

Regards,

Corey

1 REPLY
Bronze

Re: Banner MOTD's

You can probably remove the 'banner motd' command and check if the problem is due to any other vty related configuration like 'login' and 'password' commands. The debugs might also show the reason for session not getting completed.

106
Views
0
Helpful
1
Replies
CreatePlease login to create content